Blue Texture /Hammer Tone/ Wrinkle/Crocodile/Sand/ Rough Finish Powder Coating

Product Description

texture /Hammer tone/  Wrinkle/Crocodile/Sand/ Rough Finish Powder Coating

 COLORS AVAILABLE

• RAL colors coating powder
• Pantone colors
• Color-matching regarding customer requirement is available

GENERAL TYPES

• Polyester /Hybrid powder coating
• Epoxy Powder coating color
• Metallic powder coating color
• Hammer tone color powder coating
• Texture color powder coating powder

Textures include sand grain, hammer, silk pattern, sand textured, marble,metallic, multi-color.

PHYSICAL PROPERTIES

• Specific gravity :1.2 ~ 1.8g/cm3 up to colors
• Particle size distribution:100% less than 100 microns (depending on the specific indicators art effects may be, according to the special requirements of painting adjusted)
• Level of liquidity:24 ~ 27 mm

CURING CONDITIONS

180 °C ~ 200 °C (work piece temperature), 10-15 minutes

AVERAGE COVERAGE

8-12 square meters / kg, thickness 60 microns (100% of the powder coating utilization rate)

PACKING

Outside carton lined with two layers of polyethylene bags, each containing 20 kg net weight.

STORAGE AND TRANSPORT

Stored in less than 30 °C, ventilated, dry, clean room, not near the fire source, heating, avoid direct sunlight, the product in the transport should be to prevent rain, sun, prolonged sun exposure.Storage products in line with the above conditions, since the date of production, effective storage period is 6 months.Over the storage period may be re-tested and the results were consistent with, can still be used.

 

HEALTH AND SAFETY

Coating powder is a non-toxic products, but should be avoided in the course of inhalation of dust.Proposed operators wear appropriate dust mask, glasses.If possible, try to avoid long-term skin contact with powder coating

Mechanical property
Testing items	Standards and methods	Inspecting index
Impact strength	GB/T1732-1993, AS3715 2.8	>50kg/cm
Bending resistance	GB/T1185-88, AS1580 402.1, ISO9227	Pass 2-5 millimeters
Adhesion CHECKED TEST	GB/T9286-88,2mm Cross cut, ISO2409	Pass100/100, passes 0 levels
Cupdrawing:Erichsen, ISO1520	Erichsen, ISO1520	Pass 3-7 millimeters
Pencil hardness	GB/T6739-86, Mitsubishi	Pass H-2H
Chemical resistance and weather resistance
Salt spray test	GB/T1771-91,500 hours	The cross section of corrosion less than 2MM
Hot and damp resistance test	GB/T17740-79(89),1000 hours	Without air bubbles, loses the light slightly
Acid resistance	10% CH3COOH, 240 hours	Without air bubbles, the surface without damage
Alkali resistance	10% NaOH, 240 hours	Without air bubbles, the surface without damage
Heat resistance	200degree,1 hour	The color change is lower than E=1.5
Solvent resistance	MEK24 hours soaked in solvent-free	Without air bubbles, the surface without damage
Uvioresistant	QUV-313,500 hours	Gloss higher than 80% lower than the Munsell color change level
Water tolerance of	2 hours	No bubble, not falling, losing light